Linear Z-Wave Switch aprontest commands

Are you stuck at a particular point, can't find the answer elsewhere, here's the place to ask.
Posts: 5
Joined: Sat Jan 10, 2015 2:38 pm

Linear Z-Wave Switch aprontest commands

Postby mothpaul » Wed Jan 28, 2015 10:07 am

I have my zigbee lights working and I am interested in obtaining some z-wave wall switches. I am looking at the Linear Z-Wave switch. From what I have read, I think I can pair it to the rooted Wink Link, but I don't have any information on how I might issue aprontest commands to the Z-wave switch after it is paired. If anyone can show these commands, it would be appriciated.

Posts: 17
Joined: Fri Jan 23, 2015 3:56 pm

Re: Linear Z-Wave Switch aprontest commands

Postby Middyeasy » Wed Jan 28, 2015 2:22 pm

I don't see any reason this would be different then any other command once you figured out the Master ID BUT having said all the below.. I have never done a none Zigbee device!

aprontest -u -m MAsterID -t (whatever attribute #you wish to change) -v (Value of it)

you can see all that after you pair it
aprontest -a -r zwave and do whatever the instructions say to pair on the switch end.

Once paired..
do a
aprontest -l to see what its master device ID it is and then do

aprontest -l -m MAsterID to see a detailed description of what attribute it has and what values it expects you to send it.

Z-Wave does have specific commands they aren't needed for normal use.

Z-Wave Specific Operations:
--zwave_controller_reset Reset the zwave controller. USE WITH CAUTION.
Existing z-wave network will be lost.
--zwave_remove_failed Remove a failed zwave device.
--zwave_replace_failed Replace a failed zwave device.
--zwave_learn_mode Enter Learn Mode on the Zwave Controller.
--zwave_controller_shift Hand off control to another (new) Zwave controller.
--zwave_exclusion_mode Enter Exclusion Mode on the Zwave Controller.

Return to “Help me, I can't do xyz”

Who is online

Users browsing this forum: No registered users and 2 guests